Re: [問答] ospf的area設定問題

看板Network作者birdy590 (Birdy)時間7年前 (2017/12/05 14:02)推噓1(1推 0噓 0→)

留言1則, 1人參與討論串2/2 (看更多)

※ 引述《mikevada (Believe in dreams)》之銘言： : 我有一個LAB網路架構如下： : ┌–––┐ ┌───┐ : │ R1│───│ R2 │ : └───┘ └───┘ : │int 0 int 0 │ : │int 0 int 0 │ : ┌───┐ ┌───┐ : │ R3 │───│ R4 │ : └───┘int 1 └───┘ : │int 2 int 2│ : │ ┌────┐ │ : └─│ R5 │──┘ : int 2└────┘int 2 : R1、R2、R3、R4的int 0跑area 0 : R3、R5的int 2跑 area 2 : R4、R5的int 2跑 area 3 : 請問R3和R4之間是要跑area 0嗎?還是要另外跑一個area 4 ? : 請版上大大指點一下，感激不盡不懂就回去再看一次文件 https://goo.gl/TkMQFz Each OSPF network that is divided into different areas must follow these rules: A backbone area - which combines a set of independent areas into a single domain - must exist. Each non-backbone area must be directly connected to the backbone area (though this connection might be a simple logical connection through a virtual link). The backbone area must not be partitioned - divided into smaller pieces - under any failure conditions, such as link or router down events. Areas are identified by an area ID. Cisco IOS® software supports area IDs expressed in IP address format or decimal format, for example, area 0.0.0.0 is equal to area 0. If there are multiple areas in your network, you need to name the backbone area "area 0". Since this backbone connects the areas in your network, it must be a contiguous area. If the backbone is partitioned, parts of the autonomous system will be unreachable, and you will need to configure virtual links to repair the partition. A router with interfaces in two (or more) different areas is an area border router. An area border router is in the OSPF boundary between two areas. Both sides of any link always belong to the same OSPF area. 後面屬於進階班, 就不貼了~ -- ※ 發信站: 批踢踢實業坊(ptt.cc), 來自: 203.203.203.201 ※ 文章網址: https://www.ptt.cc/bbs/Network/M.1512453758.A.1BB.html