[請益] Arduino程式請教

看板ASM (組合語言)作者sdsd65676 (翻桌ING)時間7年前 (2018/01/16 07:22)推噓4(4推 0噓 3→)

留言7則, 5人參與討論串1/1

各位先進好，小弟是剛接觸Arduino的新手因為專題需求自己寫了程式碼，但是遇到了一些問題。先附上我的程式碼 int a = 3; int b = 2; int c = 4; int d = 7; int e = 8; int f = 12; void setup() { // put your setup code here, to run once: pinMode(a, INPUT); //鑰匙開關; pinMode(b, INPUT); //檔位開關; pinMode(c, INPUT); //距離感知器; pinMode(d, INPUT); //靜音開關; pinMode(e, OUTPUT); //無聲輸出; pinMode(f, OUTPUT); //有聲輸出; if (digitalRead (a == HIGH), digitalRead(b == HIGH) , digitalRead(d == HIGH)) //紅火 P檔靜音, 無聲輸出; { digitalWrite(e, HIGH); delay(250); digitalWrite(e, LOW); delay(250); } if ( digitalRead (a == HIGH ), digitalRead(b == HIGH , digitalRead(d == LOW)); //紅火 P檔有聲, 有聲輸出; { digitalWrite(f, HIGH); delay(250); digitalWrite(f, LOW); delay(250); loop; } if ( digitalRead ([code] if ( digitalRead (a == LOW ), digitalRead (b == HIGH) , digitalRead (d == HIGH)); //熄火 P檔靜音, 無聲輸出5秒; { digitalWrite(e, HIGH); delay(5000); digitalWrite(e, LOW); delay(500); digitalWrite(e, HIGH); delay(500); digitalWrite(e, LOW); delay(500); digitalWrite(e, HIGH); delay(500); digitalWrite(e, LOW); delay(500); digitalWrite(e, HIGH); delay(500); digitalWrite(e, LOW); delay(500); digitalWrite(e, HIGH); [code] delay(500); digitalWrite(e, LOW); digitalWrite(f, LOW); } if ( digitalRead (a == LOW ), digitalRead (b == HIGH ) , digitalRead (d == LOW )); //熄火 P檔有聲, 有聲輸出5秒; { digitalWrite(e, LOW); digitalWrite(f, HIGH); delay(5000); digitalWrite(f, LOW); delay(500); digitalWrite(f, HIGH); delay(500); digitalWrite(f, LOW); delay(500); digitalWrite(f, HIGH); delay(500); digitalWrite(f, LOW); delay(500); digitalWrite(f, HIGH); delay(500); digitalWrite(f, LOW); delay(500); digitalWrite(f, HIGH); delay(500); digitalWrite(f, LOW); } if ( digitalRead (a == HIGH ), digitalRead (b == LOW )); { digitalWrite(e, LOW); digitalWrite(f, LOW); } } void loop() { // put your main code here, to run repeatedly: pinMode(LED_BUILTIN, HIGH); delay(100); pinMode(LED_BUILTIN, LOW); delay(100); 目前遇到的問題是，前兩段程式碼(紅火、P檔、有無聲輸出)不會跑到也有試過不同的寫法，都會不作用就跳到第三段使用的板子是 Uno R3 再次謝謝幫忙解決的朋友~ --