[問題] ANSYS分析上的問題
想請教一下~
我在分析ANSYS的時候
出現了以下的錯誤訊息
但是我不太懂他的意思
*** ERROR *** CP= 62.531 TIME= 13:36:27
The value of UY at node 8694 is 3.733233267E+10. It is greater than
the current limit of 1000000. This generally indicates rigid body
motion as a result of an unconstrained model. Verify that your model
is properly constrained.
*** ERROR *** CP= 63.062 TIME= 13:37:03
*** MESSAGE CONTINUATION ---- DIAGNOSTIC INFORMATION ***
If one or more parts of the model are held together only by contact
verify that the contact surfaces are closed. You can use the CNCHECK
command to check the initial contact status in the SOLUTION module.
希望有高手可以幫幫我唷
謝謝~~
--
※ 發信站: 批踢踢實業坊(ptt.cc)
◆ From: 163.25.96.162
→
218.164.143.129 07/08, , 1F
218.164.143.129 07/08, 1F
→
218.164.143.129 07/08, , 2F
218.164.143.129 07/08, 2F
→
218.164.143.129 07/08, , 3F
218.164.143.129 07/08, 3F
推
163.25.96.161 07/09, , 4F
163.25.96.161 07/09, 4F
→
163.25.96.161 07/09, , 5F
163.25.96.161 07/09, 5F
推
218.164.129.66 07/09, , 6F
218.164.129.66 07/09, 6F
→
218.164.129.66 07/09, , 7F
218.164.129.66 07/09, 7F
Cad_Cae 近期熱門文章
PTT數位生活區 即時熱門文章
-1
12
